JustinOK wrote:Rich, got the test pipe installed yet???9/16" nuts/bolts on the flanges. Make sure you PB blast them good. Ratcheting wrenches work great on this, along with an air ratchet. And wear your goggles, and maybe a mask over your mouth, too. I had a face full of crap, but then again my truck is pretty old.
Not quite yet. I plan to do it today but right now it's still about 40 degrees outside. Burrrr!
Yep, already planned on goggles and dust mask. My truck is still fairly clean but there is some flaky rust on the bolts.
Hey, did you have to drop the crossmember? It looks pretty tight.

9/16" nuts/bolts on the flanges. Make sure you PB blast them good. Ratcheting wrenches work great on this, along with an air ratchet. And wear your goggles, and maybe a mask over your mouth, too. I had a face full of crap, but then again my truck is pretty old. 

Man these things sure are ugly.

